| Circuit Board / Phone | Purpose | Disposition |
|---|
| Console Card - any: | CS-07 etc. | Replace with SPA-CS02 or CS-33 and new console. |
| Older Consoles | Standard Console with BLF | Can reuse; new one has name display; limited station BLF, no trunk BLF for now. |
| Dterm I phones | ETT-4;8;16 | Can reuse or use NEC trade-in credits |
| Dterm II phones | All models? | Chip kits for 8ELC/4 DLC cards |
| 8 ELC-C | Chip Upgrade | 243532 (1) $18 Dealer Net |
| 16 ELCD | Chip Upgrade to eliminate VM password | 243533 (1 box of 2 chips) $20 Dealer Net |
| 8 ELC-A | Wastes ports - Avoid - Chip Upgrade | 243535 (5) $200 Dealer Net |
| 4 DLC | Wastes ports - Avoid - Chip Upgrade | 243536 (5)$250 Dealer Net |
| 4 TLT | Chip Upgrade | 243567 (2) $40 Dealer Net |
| 4 TLTC-B | Chip Upgrade | 243568 (2) $40 Dealer Net |
| 4 ODT-D | Chip Upgrade | 243569 (2) $40 Dealer Net |
| 4 ODTD-A | Chip Upgrade | 243570 (2) $40 Dealer Net |
| 4ODT-FMM | Chip Upgrade | 243571 (2) $18 Dealer Net |
| 24 DTI-A,B | T-1 cards | Replace with new |
| 24DTI-C | Chip Upgrade | 243609 (1) $50 Dealer Net |
| 24DTG | Chip Upgrade | 243609 (1) $50 Dealer Net |
| 24 DTR | T-1 card | OK to reuse |
| 4 RSTB | Register Sender RDS vintage | Replace? - optional chip kit, but not recommended |
| 4 RSTB-A | Chip Upgrade | 243686 (5) $100 Dealer Net |
| 8 RSTJ | Newer Register Sender | OK , but might want new one (8 RSTK) for 911 |
| IO cards, various | used for MAT, MCI link | Replace with new IMX |
| 16 LC-Q | Analog for Voice Mail, Modem card | Replace |
| 16 LC-GB analog | Wide Analog card - RDS | Avoid - takes up 2 slots - Power usage? |
| SPA-24CCTA | CCIS T-1 | OK |
| SPA-24PRTBA-B | ISDN PRI | OK |
| 8 COT | Wastes ports - RDS analog trunk card | Chip Kit 243572 (2) $40.00 Dealer Net |
| 16 COT | HDS analog trunk card | OK |
| PA-CK-00 | Receive (Slave) Clock Card for T-1 | Not Needed - IMX has receiver clock built in! |
| PA-CK-01 | Master Source Clock Card for T-1 | Replace with CK-14 (PLO-A #200419 $2500 list (see below) |
Note: Older circuits card take more power than the newer ones. Put a mix of cards in each PIM. If you are using all older cards, avoid filling up the PIM. You may need to bring up the older cards gradually on a total power shut down or on initial power up. Busy out all the cards, then bring the PIM up, then unbusy the cards one at a time.